Atari 1050 Alignment procedure#

  • Switch on drive with no disk
  • shortcut TP7 and TP8
  • connect scope gnd to TP17
  • connect scope probe to TP 10, adjust C36 to 125 KHz
  • connect scope probe to TP 9, adjust VR3 to 250 ns pulse width
  • connect scope probe to TP 11, adjust VR5 to 1 us pulse width
  • remove shortcut between TP7 and TP8

(I hope I didn't mix up TP9 and TP11 values, so please check for the smaller pulse width first and verify)

ep, 09.06.2002

Add new attachment

Only authorized users are allowed to upload new attachments.
« This page (revision-1) was last changed on 03-Feb-2023 16:21 by Carsten Strotmann  
G’day (anonymous guest) My Prefs
© 2010-2021 AtariWiki
All content in the Wiki is licensed under Creative Commons Share Alike License, unless otherwise noted.
JSPWiki v2.8.3