This is version . It is not the current version, and thus it cannot be edited.
[Back to current version]   [Restore this version]
ADRHEXADRNAMEDescriptionOS
54018$D303PBCTLPort B Controlonly A (400/800)

BitFunctionDescription
7PA7Interrupt status of SIO
6PA6always 0
5PA5always 1
4PA4always 1
3PA3Status of command line of SIO
2PA21=use Port B for data input/output, 0=define data direction, see below
1PA1always 0
0PA0Interrupt of PROCEED line on/off, set to 0 by OS

To define the data direction of PORT B, set Bit 2 of PBCTL to 0. Then write a byte to PORTB, where Bits set to 1 indicate WRITE and Bits set to 0 indicate READ. Normally PORTB is set to %00000000 (=all input).


see also: Controller topics

previous: PACTL

next: n/a

Add new attachment

Only authorized users are allowed to upload new attachments.
« This particular version was published on 22-Mar-2017 00:07 by Florian Dingler.  
G’day (anonymous guest) My Prefs
© 2010-2017 AtariWiki
All content in the Wiki is licensed under Creative Commons Share Alike License, unless otherwise noted.
JSPWiki v2.8.3